EarthQuaker Devices Avalanche Run Stereo Reverb and Delay

The Avalanche Run is a dreamy stereosonic exploratory multi-tool that includes up to 2 seconds of delay time, reverse delay, tap tempo with subdivision control, switchable true bypass or buffered bypass with 5 different tail lengths (including a sound-on-sound style lo-fi looping mode) and an assignable expression control that maps the expression jack to a control of your choice, including the toggle! The delay section allows tweaking from tape emulation to bucket brigade styles with a twist of the wide-range Tone control. The cavernous plate- style reverb has just a touch of modulation similar to the one found in the Dispatch Master only more lush with adjustable Decay. Otherworldly reverse delay and dynamic swelling reverb settings are accessible through a 3-way toggle switch. This is a limited colorway, so get it before it's gone!

This is a BRAND NEW item. If you have any questions please feel free to shoot us a message, visit us in-store or give us a call at (217) 607-8132.

SPECS:

• Time: This controls the delay time and goes from 0ms to just under 2000ms.
• Repeats: Controls the regeneration of the delay, from zero repeats to near infinite.
• Tone: Controls the tone for the delay line only. Roll off highs to the left, roll off lows to the right and get a flat response in the middle.
• Mix: The is the volume control for the delay line. This blends in the wet with dry until 1 o’clock, 1 o’clock to 3 o’clock boosts the wet signal over the dry and 3 o’clock up brings down dry until it is fully wet when all the way up.
• Expression Jack Assign Switch: Use this switch to map the expression jack to one of the assigned controls.
• Ratio Selector Switch: Selects delay subdivisions when time is set by the “Tap” switch.
• Decay: Controls the decay length of the reverb, short decay counterclockwise, long cavernous decay clockwise.
• Toggle Switch (Mode Selector)
  • Normal: This is the “standard” delay and reverb mode
  • Reverse: This is reverse delay mode with “standard” reverb
  • Swell: This is the volume swell mode
• Mix: This is the volume control for the reverb. Blends in the wet with dry until 1 o’clock, 1 o’clock to 3 o’clock boosts the wet signal over the dry and 3 o’clock up brings down dry until it is fully wet when all the way up.