Ampeg built its name on bass amps, but the V-4 is the proof they knew what to do with guitar players too.
Two channels, real spring reverb, and a three-position midrange selector that actually shifts the amp's center of gravity instead of just nudging a tone knob.
Four 7027A power tubes handle the output instead of the usual 6L6 lineup, which is a big part of why these have their own specific growl on the top end.
This one's a genuine 1970s original, built in Linden, N.J., back when Ampeg wasn't chasing a "vintage" label — it just built amps.
It's worn, it's been used, and the grille cloth shows it.
Local pickup only.
This is a USED amp in GOOD condition.
Specs
Amplifier
Builder: Ampeg
Model: V-4
Configuration: Head, Two-Channel
Output: 100 Watts RMS
Era: 1970s original production
Country of Origin: USA (Linden, N.J.)
Tubes
Power: 4x 7027A
Controls
Channels: Volume 1, Volume 2
Tone: Treble, Bass, Midrange (3-position frequency selector)
Reverb: Onboard, with Reverb Lock switch
Switching: Two Sensitivity switches, Ultra-Hi switch
Rear Panel: Standby, Polarity, Power toggles; speaker impedance selector (2/4/8 ohm); footswitch jack; external amp jacks; hum balance
